Randall Amplifiers Forum

Randall Amplifiers => General Discussion => Topic started by: Idonthaveausername on April 22, 2017, 02:49:37 PM

Title: Accutronics Reverb problems.
Post by: Idonthaveausername on April 22, 2017, 02:49:37 PM
Hi everyone, first post....
I bought a Commander 1 in which the reverb (tremolo as well) doesn't reverb.
The schematic shows a voltage of 10 volts on the output from the amp, my multimeter confirms it on my amp. Shaking the reverb I can hear the springs in the speaker.

Both coils on the reverb tank read ~166 ohms from the solder joints.

I conclude that the problem lies in the tiny magnets with the spring hooks, do they lose their magnetism? What would cause this area to fail? That's if it is that area at all.

Thanks.
Title: Re: Accutronics Reverb problems.
Post by: Lafleurz on May 31, 2018, 04:22:09 AM
I would like to know about the content that you have a source of knowledge that can guide me?
Title: Re: Accutronics Reverb problems.
Post by: Jirayurth on June 13, 2018, 11:19:49 PM
I was looking for a solution to the problem with the resonance of Accutronics as well.
Title: Re: Accutronics Reverb problems.
Post by: Lindsayso on September 02, 2018, 10:16:09 PM
volts on the output from the amp, my multimeter confirms it on my amp
Title: Re: Accutronics Reverb problems.
Post by: Johnwick88 on September 24, 2018, 11:44:59 PM
Do you have clear instructions for this or not?

Or should I buy a new version?

Royal Online Mobile (https://gclub.royal-ruby888.com/royal-online-mobile.html)


Title: Re: Accutronics Reverb problems.
Post by: Betagan on January 09, 2019, 03:02:02 AM
I think it took a new version.